代做CBE 9112 Design and Analysis Principles Simulation Assignment # 1帮做R语言

CBE 9112 Design and Analysis Principles

Simulation Assignment # 1

Due: October 11th, 2024 (submit in OWL)

Include the following:

a)  Hysys simulation file for each problem (you may simulate all problems in one file for your convenience)

b)  Clearly report your answers either in the Hysys file itself or in a Word document

Problem 1:

The stream whose composition is given in the table below is to be pumped from 25 to 100 psi. The inlet temperature is -10 °C. Use the pump block to calculate the energy required if the pump’s efficiency is 80%. What is the outlet temperature?

Component	Molar Flow (Lbmol/h)
Methane	0.1
Ethane	1
Propane	10
n-Butane	18.9
i-Butane	20
1,3-Butadiene	20

Suggested Fluid package: Peng Robinson

Problem 2:

Water at 25°C and 2.5 atm pressure is being transferred with a 2 hp pump that is 75% efficient at a rate of 15 m3/h to a storage tank 20 m high. All the pipes are 4-inch, schedule 40, mild steel, except for the last section, a 2-inch. There are three standard 90° elbows and one reducer to connect the 2-inch pipe (115 m long), as shown in the Figure below. Find out the pressure drop across the system.

 

Suggested Fluid package: ASME Steam